• Guaranteed Fulfillment

    Always the correct part

  • In-House Experts

    We know our products

  • Added Value

    Post Sales Support

  • USA Delivery

    Free shipping over $350

Wall Rack Bracket for EZ-Tranz Gold Transfer Boards MCM199

(No reviews) Write a Review
Wall Rack Bracket for EZ-Tranz Gold Transfer Boards  MCM199

Wall Rack Bracket for EZ-Tranz Gold Transfer Boards MCM199


Wall Rack Bracket for EZ-Tranz Gold Transfer Boards

Constructed of stainless steel material, this wall rack is designed for ease of cleaning and the prevention of infection spread. It is compatible with all sizes of EZ-Tranz Gold transfer boards, helping you keep your boards clean and readily accessible in the spot you need them.

Each rack is designed to hold one board securely. Please note that mounting hardware is not included with the rack due to varying substrates. You may need to provide your own mounting hardware to ensure proper installation.

Manufactured by Mid Central Medical, MCM

Factory id: MCM199

Cleaning and Maintenance

The attractive and hygienic surface appearance of stainless steel products cannot be regarded as completely maintenance free. All grades and finishes of stainless steel may in fact stain, discolor or attain an adhering layer of grime in normal service. To achieve maximum corrosion resistance the surface of the stainless steel must be kept clean.

Stainless steel is easy to clean. Washing with soap or a mild detergent and warm water followed by a clean water rinse is usually quite adequate for most medical equipment. Use a soft brush or cloth to remove stubborn dirt or blood. Do not use abrasive clothes or pads that will alter the finish of the stainless steel. An enhanced appearance will be achieved if the cleaned surface is finally wiped dry. We do not recommend using a cart washer for stainless steel equipment unless it is specifically rated for using in a cart washer. This can damage wheel bearings, parts glued on may release due to heat and water may be retained on some pieces of equipment. This can void manufacturer’s warranty.

Most stainless steel equipment does not need to be sterilized as it is usually not in direct contact with surgical instruments. If stainless steel is required to be sterilized, please check with sterilization equipment manufacturers for settings as equipment cycles vary.

After stainless steel has been cleaned, you will want to disinfect before use. This is best done with disposable wipes not containing chlorine bleach. If bleach wipes are used, you will need to do a final rinse with clean water to remove the bleach residue as it will cause the stainless steel to have a cloudy finish or white residue over time. We recommend using Super Sani-Cloth® Germicidal Disposable Wipes to disinfect stainless steel medical equipment.


Customers Also Viewed